AUTONET TV

Power Steering Service in North Kingstown

Most North Kingstown drivers are too young to remember life before power steering - cranking those great big steering wheels! It was a pretty good workout. Now power steering is standard. Let's look at how it works. The heart of any power steering system is its pump. The pump pressurizes the power steering fluid that provides assist for steering. Most pumps are driven by a belt that is run by the engine; a few are electrically powered. A high-pressure hose passes fluid from the pump to the steering gear. A low pressure hose returns the fluid back to the pump.

These hoses can develop leaks, so it is a good idea for North Kingstown drivers to have them inspected at every oil change. Low fluid can damage the power steering pump. That is why power steering fluid level is on the checklist for a full-service oil change. The fluid needs to be compatible with the hoses and seals, so check your owner's manual for the right type - or just ask your friendly and knowledgeable pros at Hans Imports in North Kingstown.

The fluid cleans, cools and lubricates the power steering system. It breaks down as the years go by and collects unwanted moisture, so North Kingstown drivers need to replace it from time to time. Many vehicle manufacturers specify power steering service intervals. Unfortunately, this important service is sometimes left off the car maintenance schedule for many of us. So, when in doubt, every 25,000 miles/40,000 km or two years is a good fallback. Your technician at Hans Imports will use a detergent to clean the system, flush out the old fluid and replace it with the good stuff.

Here are some  warning signs of trouble with your power steering: It's harder to turn the wheel, there's erratic power assist, you hear loud whining coming from the pump (which may be difficult to hear over the loud whining coming from the backseat), you have to top-off the fluid frequently, or you hear squealing belts. Remember to never hold the steering wheel to the far right or left for more than a few seconds at a time. That will wear out your power steering pump quickly.

Other steering components can be bent or damaged from wear or hard knocks: ball-joint, idler-arm, steering-gear, steering-knuckle and tie rod to name a few. Warning signs here are steering play, wandering, uneven tire wear and an off-center steering wheel. An annual alignment check at Hans Imports in North Kingstown will reveal bent or damaged steering components.

Most SUV's, pick-ups and rear-wheel-drive cars need regular front-wheel-bearing service.

The bearings should be cleaned and inspected. If they are excessively worn, they need to be replaced. The bearings are then repacked in clean grease. The team at Hans Imports also recommends the wheel-seal be replaced when the bearings are serviced. Like everything else, check your owners' manual maintenance schedule. It's usually required around every two years or 40,000 miles/64,000 km. If you drive through water in the North Kingstown area, the bearings will need service more often.

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
http://www.hansimports.net
 

Everything You Ever Wanted to Know About Wheel Bearings

Why are wheel bearings for North Kingstown vehicles important? It's simple: your wheel bearings keep the wheels on your vehicle. In today's Hans Imports post, we'll discuss more about wheel bearings and how you can make sure they can do their very job while you drive around North Kingstown, RI.

Wheel bearings are pretty simple parts. They're made of high quality steel and are engineered to last 100,000 miles (160,000)  or more if properly cared for. The bearings do two jobs: First, they allow the wheel to freely rotate with as little friction as possible. Second, they support the weight of the vehicle. For example, if your car weighs 3,600 pounds (1600 kilogram), each wheel has to support approximately 900 pounds (400 kilograms). That's a lot of heavy lifting over those long distances.

Even though wheel bearings are pretty straightforward, they need to be in near perfect condition to do their job for North Kingstown vehicles. The bearings are packed with heavy grease to lubricate and protect them. A seal keeps the grease in and water and dirt out. It's when the seal starts to leak that problems begin. The grease can become contaminated, causing the wheel bearings to overheat and ultimately fail.

The first sign that your wheel bearings are in trouble is an unusual noise coming from a wheel. It could be a chirping, growling, rumbling or a cyclic sound. The noise could get louder or even disappear at certain speeds. Your technician at Hans Imports can inspect for bearing wear by lifting the vehicle and checking for play in the wheel.

Now some wheel bearing assemblies are factory sealed. That means that they cannot be serviced – they can only be replaced. Those that aren't sealed can be serviced on schedule at Hans Imports. The bearings are removed, cleaned and inspected. If the bearings are still good, they're re-installed – if not, they're replaced. They are then packed in grease and a new seal is installed.

If your vehicle has a factory sealed wheel bearing assembly, the entire assembly needs to be replaced when trouble arises. Unfortunately, the parts are pretty costly – but they usually last about 150,000 miles (240,000 kilometers) as long as the seals hold up.

Now, even a good seal cannot keep out water that's exerting pressure on the seal. So if you've driven through hub-deep water, your bearings should be cleaned and repacked if they're serviceable. If you have factory sealed bearings, you just need to watch for signs of premature failure. If your wheel bearings can be serviced, your manufacturer's owner's manual will recommend an interval, usually around 30,000 miles (50,000 kilometers).

If you have any sort of trailer, don't forget its wheel bearings. They probably need to be serviced even more frequently. This is especially true for boat trailers that are used to launch the boat by backing it into the water. These should be serviced every year, usually at the end of the season so that the bearings don't have the opportunity to rust all winter.

So what happens to North Kingstown vehicles if wheel bearings fail? Well, the wheel can literally fall off the vehicle. I don't need to tell you how that could be. So check with your service advisor at Hans Imports and see if your vehicle's wheel bearings can be serviced and when it's recommended. Listen for warning signs. If you've been fording streams or puddle surfing after rainstorms, be especially vigilant.

Visit the automotive professionals at Hans Imports for a wheel bearing inspection. 

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
http://www.hansimports.net

What's in a Number? (What Tire Numbers Mean)

You've probably never paid much attention to the writing on the sides of your tires, but they contain a wealth of information.  There's a long combination of letters and numbers that can tell you a whole lot about what tires your vehicle was designed to be riding on.  Let's check out this example found on an SUV: P245/70R17 108T.

The first letter, P, means it's intended for passenger vehicles.  If there's no letter, it means it's a metric tire.  If there's an LT at the beginning or end that means a tire designed for light trucks.

Moving on to our example, the 245 shows how wide the tire is in millimeters from sidewall to sidewall.  The number that follows in our example, 70, means the height of the tire is 70% of its width.  The letter after that in our example, R, describes the type of tire (on this vehicle, radial).  Following that is the diameter in inches, in our SUV example, 17 inches. 

How much load the tires' sidewalls are designed to take is what that next number is all about (108 in our example).  The higher the load index, the more weight the sidewalls can take.  And the last letter is the speed rating of the tire, in our example, T.  The further along in the alphabet that letter is, the higher its speed rating.  So now you know what those letters and numbers mean.  But why are they important?

When you are getting ready to replace those tires, those numbers are telling you what the original equipment was when your vehicle was new.  Sticking with the same rated tires is always a good idea.  If you don't know what you're doing, trying different sized tires and wheels can cause real issues when it comes to performance and safety, considering all the computerized systems now found on vehicles.  When in doubt, consult your service advisor when it comes to buying new tires.  He or she knows what those tire numbers and letters mean… and a whole lot more.

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
http://www.hansimports.net

What is a TPS? (Throttle Position Sensor)

You know you have an accelerator pedal; step on it and your vehicle is supposed to go.  But did you know there is a part in your vehicle that keeps track of where the throttle is? It's called the Throttle Position Sensor, or TPS.

The TPS is a sensor that helps your vehicle figure out the right mix of air and fuel is reaching your engine.  It does that by keeping track of the throttle and sending that information to your vehicle's computer.  Other factors play a role in how well your engine is performing, including air temperature, how fast the engine is turning over and air flow. 

When the TPS isn't working right, you may find your vehicle won't accelerate or doesn't have the power you're expecting when you press on the accelerator.  In some cases, it may accelerate on its own.  Sometimes your vehicle won't go over a certain speed.  Your Check Engine light may go on.

Any of these symptoms should be checked out soon.  If your TPS stops working right, your vehicle may not be safe to drive.  Fortunately, most vehicles have a "limp home" mode that will allow you to get off a busy road to a safe spot. 

Your service advisor can let you know which TPS is the correct replacement for your vehicle.  Your shop may have to re-program the new TPS so it works correctly with other software in your vehicle.

It's a fact of life these days that computers control many of a vehicle's functions. The sensors that feed information to those computers help make your vehicle work the way it was engineered to and keep you motoring down the road safely and efficiently.

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
http://www.hansimports.net

Cooling System Components

Today we want to talk about a system in our vehicles – the cooling system. It's one of those things that North Kingstown auto owners don't give much thought to until it fails and then they're stranded by the side of a road in RI.

Cooling systems fail more often than any other mechanical system – usually because of neglect. Don't you hate it when something breaks and you could have done something to prevent it?

The good news is that if North Kingstown drivers take care of their cooling systems, they can keep working for the life of their car.

Here at Hans Imports in North Kingstown, we emphasize preventive maintenance services like replacing your coolant according to the factory schedule. But the various parts that make up the cooling system need attention too. The major components of the cooling system are the water pump, freeze plugs, the thermostat, radiator, cooling fans, the heater core, the pressure cap, the overflow tank and the hoses.

It sounds complicated, but we North Kingstown residents don't have to be experts – we can leave that to our friendly and knowledgeable service advisor at Hans Imports. But, having an overview will help us remember how to take care of your car's cooling system.

Most North Kingstown folks would be surprised to know that burning fuel in your engine produces up to 4,500 degrees F/2,500 degrees C of heat. And all that heat has to be dealt with. If the heat can't be drawn off the engine, the pistons will literally weld themselves to the inside of the cylinders – then you just have to throw the engine away and get a new one. That would cost thousands of dollars.

Now the water pump is what forces the coolant through passages in the vehicle engine to absorb heat. The pump is driven by a belt that needs replacement from time to time. And the water pump will eventually wear out and need to be replaced. Spending some cash on replacing the belts and water pump is much less than the cost of repairing the extremely massive damage that can be done when an engine seizes.

There's another little known but important part of the coolant system that protects the engine. It's called a freeze plug. If you remember from high school chemistry, water expands when it freezes. In very cold areas, the coolant can actually freeze when the vehicle is left sitting.

It is hard to believe, but the expanding frozen coolant is enough to actually crack the engine block. The freeze plugs fit into the engine block. They fit tight enough to withstand the pressure of a running engine, but can expand or pop out if the coolant freezes. These little things save a lot of engine blocks.

The team at Hans Imports can check your cooling system and make any necessary adjustments or repairs. Give us a call.

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
http://www.hansimports.net