AUTONET TV

Objects in the Mirror (Rearview Mirror Safety and Maintenance)

You may remember a song that went, "Objects in the rearview mirror may appear closer than they are." While that was a song about life's lessons, there are a few things we should all know about how important rearview mirrors are to safe driving.

While new electronic devices are helping drivers be aware of surrounding traffic in high-tech ways, the good old rearview mirror is still a dependable way of letting you know what's around you.  There are usually 3 on each vehicle, 1 attached to the windshield inside and 2 attached outside on each of the front doors.

It's important that they be adjusted properly before you start driving (not while you're driving). Experts say the windshield rearview mirror should cover the area behind the vehicle while the outside mirrors should not simply duplicate that view but extend it to the sides, where blind spots normally are.

Your rearview mirrors must be able to hold the positions they're adjusted in; it there's play in them or they move around, you'll never be sure they're pointed in the direction that will let you see where traffic is.  The one on the windshield must be firmly attached.  If it won't stay where you want it, head to your service facility where they can tighten it or replace any parts necessary to let the mirror maintain its aim. If it has fallen off the windshield completely, a technician can reattach it with the proper adhesives or fasteners.  There may be electronics that need to be properly connected as well.

The outside mirrors cover your blind spots and they must be able to hold their adjustments, too.  Many adjust electronically; switches and motors can fail, electrical connections can detach or become corroded and the reflective glass can crack, discolor or develop a hazy fog.  A technician can diagnose and repair those problems and recommend any replacement parts you might need.  Mirrors that are adjusted manually also should be restored to proper working order in order for you to maintain this important rear visibility.

Drivers don't think about their rearview mirrors all that much.  On reflection, don't they deserve respect and care for the important job they do?

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
www.hansimports.net

Keep It Smooth: Chassis Lubrication

If you have a truck, SUV or older car, chances are your vehicle has grease chassis fittings that need regular maintenance.  Having them lubricated can give you a smoother, quieter ride and prevent more expensive repairs down the road. 

It’s especially important on parts that have to move a lot, especially when you are carrying heavy loads.  Components such as ball joints, U-joints, tie rod ends and control arm bushings need fresh lubricants which prevent metal rubbing against metal, friction, heat and early wear.  

When you bring your vehicle in to us to have your chassis lubricated, you’ll likely notice that your steering will feel more responsive, just like it used to.  Plus, you’ll get a smoother, quieter ride, with little or no squeaking when going over bumps. Another benefit is your vehicle will keep its alignment better, and your ride will generally feel more comfortable.

Chassis lubrication is recommended for many vehicles about every 6,000-8,000 miles/10,000-13,000 km.  One easy way to think of it is that you should have it done about the same time you get an oil change.  After all, it’s kind of like an oil change for your chassis. It’s especially important if you drive on rough surfaces, in harsh weather or carry heavy loads.

If you drive a newer car, you probably don’t need this service, since the latest automobiles have sealed suspension components that are designed to not require lubrication.  

But if your vehicle has a suspension that needs lubricating, consider it a good investment in your vehicle’s safety, repair costs and your comfort. 

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
www.hansimports.net

Distributor Cap and Rotor Replacement

If your vehicle is newer than the mid 2000s, it likely doesn’t have a once-popular ignition system which uses a distributor cap and rotor.  But if your vehicle is old enough to have them, it’s important to make sure they receive regular attention since they’re instrumental to your engine running smoothly.

Here’s now a distributor cap and rotor system works.  The distributor cap sits on top of the distributor, while the rotor goes around underneath it. They take high-voltage electricity from the ignition coil and send it to each spark plug in the correct firing order. That is what enables your engine to run smoothly and efficiently.

Because they’re mechanical, eventually the distributor cap and rotor will wear out. Think how much heat, vibration and electrical stress the distributor cap is endures. That can result in it cracking and the terminals corroding.  Another problem may develop called is called carbon tracking where a line of carbon acts as a conductor to bypass the usual route the electricity takes. Plus, the rotor can wear down and the spark may wind up going to the wrong cylinder.

You’ll notice signs like the engine is hard to start (if it starts at all), it misfires, your fuel economy deteriorates, your power decreases or idling is rough. If you drive in a damp or humid climate, moisture can also interfere with the electrical path.

It’s important to have a technician regularly replace the distributor cap and rotor, typically anywhere from 30,000-50,000 miles/50,000-80,000 km.  Each manufacturer has its own interval, so it’s best to follow their recommendation.  After the distributor cap and rotor are changed out, you should notice much better performance. And your vehicle will be more likely deliver the reliability you’re expecting.

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
www.hansimports.net

Taking the Heat (Heater Hose Maintenance/Repair)

If you have an internal combustion vehicle, you know it has a lot of hoses that carry various fluids.  And if you have a heater in your vehicle, you'll have heater hoses.

A heater hose connects to and from the engine so some coolant can be circulated through a little radiator called a heater core.  In cold weather, that heater core acts as a heat exchanger to heat up your cabin.

Even in the hot weather, the heater hoses can prove problematic.  That's because they may remain pressurized even though you're not running your heater.  Heater hoses are made out of tough materials since they must handle heat and pressure.  But even the durable rubber, plastic and metal they are made out of can crack or leak from years of use.  That means coolant can be sprayed out into the engine compartment or leak onto a driveway or garage floor. 

You may be able to see a puddle of coolant under your vehicle or perhaps smell the odor of the coolant under the hood.  Some say it has a sweet smell.  Another sign coolant may be leaking out of the heater hoses is your engine may be running hotter.   You'll be able to tell by watching the heat gauge on your dash.  Let's say your heat gauge usually points just slightly below halfway between the C and H (Cold and Hot) of the heat gauge.  But now it is just slightly above.  That's enough to tell you that the coolant temperature has gone up a little, a possible sign of trouble.

This is a good time to swing by your service facility and have them take a look. If they catch the leak when it's small, it's a relatively simple matter of draining the coolant, replacing the hoses and replacing the coolant.  Sometimes, though, a heater hose can suddenly burst and a lot of coolant can leak out quickly.  That can, in turn, cause your engine to start to overheat.  In that case, you may see your vehicle's temperature gauge shoot up pretty quickly.  Then it's best to pull over and have your car towed to a repair facility since driving with no coolant can cause severe engine damage.

Preventative maintenance is your best insurance against heater hose problems.  A technician will periodically check for any signs of cracks or leaks.  You should expect to replace a heater hose at least once during the time you own your vehicle.

Hans Imports
7275 Post Rd
North Kingstown, RI 02852
(401) 295-7785
www.hansimports.net